User´s Manual
Audio/Video Transmitter & Receiver
78
A/V transmitter & receiver not only allows you to send crisp audio/video from one area
to another, it also gives you the ability to control the source using your existing remote
control device. The infrared (IR) signal emitted by your remote control is converted to a
radio frequency (RF) signal at the receiver and then sends it back to the transmitter,
where the RF signal is converted back to the original IR signal and heamed to the
audio/video source.
The IR Extender Mouse connects to the transmitter through its own special
connector plug. The extender mouse emits a high intensity IR signal, bathing your
components with the remote signal. To use the IR extender mouse, follow the instructions
below.
1.-
Plug the IR extender mouse into the jack located on the backside of the transmitter
housing. The jack to the IR extender mouse is marked as “IR”.
2.-
Locate the IR sensor on the source component you wish to control. If the sensor is
not clearly labeled on the front of the component, either consult the owner´s manual
for that component or perform a simple test to find it.
3.-
Orient the IR extender mouse housing so that it points in the general direction of the
IR sensors of the source components you wish to control. Secure the IR extender
mouse to the stereo cabinet shelving or door in this position.
4.-
Position the receiver so that your remote control signal can strike the IR window on
the bottom front of the unit. To use your remote control, point it at the front of the
receiver.
Using the Remote Control Feature
How to use the IR Extender Mouse
