USER’S GUIDE
20
USER’S GUIDE
15
ON (I)
Position
(Lower)
OFF (O)
Position
(Higher)
Red - Power ON
Green - Ready to use
3)
Once the unit has been fully assembled and filled with water, plug in the Power
Cord to a grounded electrical outlet. The RED light - Power Indicator will indicate
when power is on. Power Switch ( O / I ) is in the OFF ( O ) position (higher position).
Wait for the Ready-to-Use indicator to turn Green - approximately 20 - 30 seconds.
GREEN light will turn on when the steam mop is ready for use.
When the Ready-to-Use indicator light turns Green press the Power Switch ( O / I )
to the ON ( I ) position (lower position). The mop will start emitting steam.
To stop emitting steam turn OFF ( O ) the unit by pressing the Power Switch ( O / I )
again.
If the Power Switch ( O / I ) is pressed
(lower position) prior to Ready-to-Use
light indicator turning green, water from
the previous use will not be heated
and will be forced out by present steam
and will cause puddling to occur.
This may also happen if the Power
Switch was left in the ON ( I ) position
(lower position) from the previous use
and the unit was disconnected by
unplugging only. Make sure to turn
the unit OFF after each usage and
then disconnect from the electrical
outlet so the unit is in the OFF ( O ) position when used next time.
4)
Slowly pass over the surface to be cleaned. The absorbent mop cloth picks up
the dirt loosened by the steam. Apply steam liberally. Keep a towel handy and wipe
away any excess water that may accumulate.
5)
When the H2O MOP X5™ stops emitting steam, simply turn OFF and unplug
the appliance, refill the Water Tank and continue cleaning.
20
USER’S GUIDE
20
GARMENT STEAMING TOOL
4.
To use the Window Cleaning tool as a Garment Steamer, install the Microfiber
Cloth or the Lint Cloth over the Window Cleaning/Garment Steamer Tool
(as illustrated in Fig. 4a, 4b & 4c).
5.
Attach the Window Cleaning/Garment
Steamer Tool to the Extension Hose as
follows: Align the lock button on
the Extension Hose with the designated
hole on the Window Cleaning/Garment
Steaming Tool Frame and then push the
Extension Hose until it locks in place (as illustrated in Fig. 5a)
DUSTER
6.
Install the cleaning
Coral Cloth onto the
Duster Frame (as
illustrated in Fig. 6a & 6b).
7.
Attach the Duster Frame to the Extension Hose as follows:
Align the lock
button on the
Extension Hose
with the designated
hole on the Duster
Frame and then
push in the Extension Hose until it locks in place (as illustrated in Fig. 7b).
6a
6b
4a
4b
Black Tag
4c
Tag
side
back
5a
7a
7b
