TELETRAC NAVMAN TM470 Series, Installation Overview

Page: 61 / 65

Troubleshooting using attached display continued
IO -
This button show you if the unit is receiving ignition & input signals along with sleep entry time. It will display the following: PM:ENTRY DLY 00h00m00s
OP1: ON FIL: OK IGN:ON* IN1:OFF IN2:OFF IN3:OFF IN4:OFF MDT:OFF SHOCK:OFF
Notes:
The PM: Entry: this number should count up after you cut the ignition off.
OP1 shows if Output 1 is on or off when you activate an input the status will change from on to off.
OP2 shows id Output 2 is on or off when you activate an input the status will change from on to off.
IGN: shows if the ignition is on or off. When you turn the ignition on the status will change from on to off.
IN1: shows if input 1 (gray/black wire) when you activate it the status will change from on to off.
IN2: shows if input 2 (orange wire on TM2J) when you activate it the status will change from on to off.
IN3: shows if input 3 (orange on TM450 &TM2) when you activate it the status will change form on to off.
MDT: N/A; Shock : N/A
VLU -
This button shows you the mode of the unit. It will display the following: AVLU:Active; Modem: Online; GPS:ACQED; USR:LOGOUT;
SCR:DisARMD; FIL:NJ
Notes:
AVLU: This tells you if the unit is active
Modem : Tells you the status of the Modem
GPS: Tells you if the unit has GPS
USR: N/A ; SCR: N/A
FIL: This tells you why the FIL light is staying on.
Versions-
This tells you what firmware the unit has. It will display the following:
TM VLUplus (TM470)
AppVer: (16. XXX.XX)
61