TELETRAC NAVMAN TM470 Series, Installation Overview

Page: 10 / 65

TM470V6 VLU placement
•
All equipment and wiring must be installed in a manner that will conceal its location.
•
Installation must be in a dry location with minimal exposure to dust ,moisture ,heat and unnecessary vibration.
•
It is always best to mount the unit to a flat surface; it should not be mounted on curves, dips or humps since this can degrade the security of the
unit.
•
Mount the unit to the chassis of the vehicle utilizing the mounting tabs. Always secure the unit with screws or zip-ties.
•
Always check behind the place where any screws will penetrate to make sure you are not going to drill into a fuel or brake line, wiring harness,
etc.
•
Be careful when mounting touching an existing factory harness because vibration may cause an electrical short. Great care must be taken to
prevent chaffing.
•
Mount the unit so it will not cause any physical interference with the normal operation of movable equipment in the vehicle such as seats,
pedals, hinges, air conditioning vents, etc.
•
Never mount any component to vehicle air lines. Damage to the air lines will cause a catastrophic failure disabling the use of the vehicle.
10