Qtanium 400 | Installation Manual
19
8
Black
Ground
Ground Output
9
Brown/White
RxD-3
RS232 Serial Port 3/receive
10
Brown
TxD-3
RS232 Serial port
3/transmit
11
Yellow
DO-1
Digital Output 1
12
Red
~+12/24 V Power supply output
13
Orange/Black
RTS-1
RS232 SP1/Request to
Send
14
Black/White
TxD-1
RS232 Serial Port
1/transmit
15
Red/White
RxD-1
RS232 Serial Port 1/receive
16
Pink
CTS-1
RS232 SP1/Clear to Send
17
N/A
Shipping
Internal Battery disconnect
18
N/A
Shipping
Internal Battery disconnect
4.8.7
Connection to a Quake Satellite Modem
If you want to connect the Qtanium 400 to a Quake Satellite Modem, you need the 18-Way
satellite modem cable.
Satellite Modem for Qube 4 and Qtanium 400 Installation Manual.
4.9
Power Up the Qtanium 400
When the installation is complete, perform the following steps in the order listed to bring
the Qtanium 400 online promptly.
1.
Screw the cellular (TNC) antenna cable to the connector on the Qtanium 400.
2.
Screw the GPS (SMA) antenna cable to the connector on the Qtanium 400.
3.
Insert fuses into fuse holders.
4.
Remove and RETAIN the shipping plug from the 18-Way connector. If you have not
installed an 18-way cable, attach a blanking plug. (The shipping plug is used to Cold
Reset the Qtanium 400 in the unlikely event of any problems – see section 5.2.)
5.
Test the installation as described in the following section.
Note When using the satellite modem, be aware that some of the I/O will be reserved
for satellite use.
