7. Take the 4 thumb screws for each monitor (the prompter
monitor and the reference monitor) and thread them one turn
into the back of each monitor. Be sure to not mix the screws up
as they are specific to each monitor. For the prompter monitor,
use the outer 4 holes. For the reference monitor, use the inner
holes.
8. On both the prompter monitor plate and the reference
monitor plate, you will find keyholes that correspond with
the thumb screws on the back of each monitor. First take
your prompter monitor and sit in inside the keyholes. Then
slide the monitor back as far as the keyhole will allow and
tighten to secure the monitor.
9. If your prompter monitor still has the two phillips head screws in
it, remove them now.
10. Take the two long thumbscrews and insert them
through the two holes along the top center of the ClockOne.
Thread them into the two corresponding holes on the face
of the prompter monitor Tighten to secure.
