Page 6
www.telematrix.net
Mitel 3300ICP Setup Notes
System based configuration is recommended since Telematrix SIP phones can’t support device based
call transfer (supervised or unsupervised).
The following steps show how to program a 3300 ICP to connect with the Telematrix SIP phone.
Network Requirements
•
There must be adequate bandwidth to support the voice over IP. As a guide, the Ethernet
bandwidth is approx 85 Kb/s per G.711 voice session and 29 Kb/s per G.729 voice session
(assumes 20ms packetization). As an example, for 20 simultaneous SIP sessions, the Ethernet
bandwidth consumption will be approx 1.7 Mb/s for G.711 and 0.6Mb/s. Almost all Enterprise
LAN networks can support this level of traffic without any special engineering. Please refer to the
3300 Engineering guidelines for further information.
•
For high quality voice, the network connectivity must support a voice-quality grade of service
(packet loss <1%, jitter < 30ms, one-way delay < 80ms).
Assumptions for the 3300 ICP programming
•
The SIP signaling connection uses UDP on Port 5060.
