Page 52
www.telematrix.net
Speed dial and Touchlite Message keys are programmed under Advance -> Memory Key
MWI Number
is the field for programming the Red
Message Waiting Indicator
Touchlite.
In this example, it is programmed to dial number (7001) on the IP/PBX for retrieving
voicemail messages.
Manual Programming - Programming the 3300IP via the LCD and Submerged Keys
There are 2 submerged keys (above the 10 speed dial keys/underneath the faceplate). The left (store) key is used
to store speed dials as well as enter the internal menu to check status and program the phone.
1.
Speed Dial
: To program a speed dial, Press the store key… press the digits you want stored… press a speed
dial key.
2.
Internal Menu
: To enter the
phone’s internal menu, hold down the
left (store) key for three seconds. At
that time, you will be prompted to
enter the password (default password
= 123) then press the other key (right
key = flash) to enter the LCD
navigation menu.
Vol up key navigates up
Vol Down key navigates down
Right/Flash key is Enter/Select
Left/Store key is Escape (back out of that
menu option)
To determine the IP address assigned to the phone, Navigate to Config -> Network -> WAN -> Status using the
keys and process outlined above.
Reset to Factory Default
To reset the phone to the factory default settings, press “#” during the startup procedure (At power up you can
see a black progress bar). The phone will enter into “post” mode, then input
* # 1 6 8
Then you will see
“clearing conf” on the screen, next you see “conf reset”. Now you have reset to the default settings. Finally, cycle
power (remove and replace WAN power cable) to restart the phone with factory default settings.