SAFETY INSTRUCTION
5
Safety Guidelines
General Guideline
CAUTION
Do not place any heavy object on T3PS36006.
Avoid severe impacts or rough handling that
leads to damaging T3PS36006.
Do not discharge static electricity to T3PS36006.
Do not block or obstruct the cooling fan vent
opening.
Leave a space around T3PS36006, at least 3cm to
the left and right.
Do not perform measurement at circuits directly
connected to Mains (Note below).
Do not disassemble T3PS36006 unless you are
qualified as service personnel.
(Measurement categories) EN 61010-1:2010 specifies the
measurement categories and their requirements as follows.
T3PS36006 falls under category I.
Measurement category IV is for measurement performed at the
source of low-voltage installation.
Measurement category III is for measurement performed in the
building installation.
Measurement category II is for measurement performed on the
circuits directly connected to the low voltage installation.
Power Supply
WARNING
AC Input voltage: 115V/230V ±15%, 50/60Hz
Connect the protective grounding conductor of
the AC power cord to an earth ground, to avoid
electrical shock.
Fuse
WARNING
Fuse type: T10A/250V
Make sure the correct type of fuse is installed
before power up.
