Teledyne ProEM Series, System Manual

Page: 22 / 162

22 ProEM System Manual Issue 3
2.2.5 Connectors
Figure 2-4 shows the connectors and indicators found on the rear of the ProEM
camera.
Figure 2-4: ProEM Connectors and Indicators
Refer to Table 2-1 for information about each connector and indicator on the camera.
Table 2-1: ProEM Connectors and Indicators (Sheet 1 of 2)
Connector Description
Gig-E Gigabit Ethernet connector. Used with the Cat 5e/6 Gigabit Ethernet cable
(supplied) interconnecting the camera and the GigE interface card in the host
computer. A high quality cable must be used to preserve data integrity during
transmission. The cable can extend the distance between camera and the host
computer by more than 50 m.
Shutter
LEMO
®
connector provides the shutter drive pulses for driving a Teledyne
Princeton Instruments-supplied 25 mm external shutter. Camera power must be
off before connecting to or disconnecting from this connector.
NOTE: When there is an installed internal shutter, this connector cannot drive
an external shutter.
Power 24 V
DC
(5.3 A max) input and TEC control from power supply.
Ext Sync
0 to +3.3 V logic level input (TTL-compatible) that has a 10 k

pull-up resistor.
Allows data acquisition and readout to be synchronized with external events.
Through software, positive or negative (default) edge triggering can be selected.
4
4
11-
0126
_00
0
4
SHUTTER
POWER
EXT SYNC
LOGIC OUT
GIG-E