QUICK START GUIDE
Do721-series Outdoor Vandal Camera
SAFETY
1. This quick start guide is designed for users who have an adequate
knowledge of CCTV cameras.
2. For maximum optical clarity, the camera or lens must remain clean.
Use a soft, dry cloth to remove finger prints and dust from the
dome cover
3. Ensure the supplied voltage meets the power consumption
requirements of this camera before powering the camera on.
4. To avoid electrical shock and to preserve the product warranty,
DO NOT disassembles the camera. Refer servicing to qualified
personnel only.
5. For more details on installation and operation, please refer to the
CD provided.
PACKAGE CONTENTS
•
Flat Head Screw (Tapping Type) x4
•
Plastic Anchor x4
•
Security Tort wrench x1
•
O-rings x4
•
2nd video monitor output cable x1
•
Rubber gasket x1
•
Guide Pattern sticker x1
•
Flush Mount template (the box lining) x1
•
Fully Assembled Camera x1
MOUNTING THE CAMERA (SURFACE MOUNT)
1. Attach the Guide Pattern Sticker to the wall or ceiling.
2. Drill two holes on the mounting surface and insert the plastic anchors (#1) into the
holes.
3. Complete drilling 2 holes on the base of the camera to match the 2 holes drilled
on the mounting surface.
(Recommendation: Surface conduit should point down to create a drip-loop.)
4. Remove the protective film from the black rubber gasket and adhere to the base
of the outdoor model cameras.
5. Secure the bottom case to the wall or ceiling with the Flat Head Screws (tapping
type) (#2).
For your convenience, the holes on the outdoor housing are started but not drilled
all the way through for moisture control.
Note: Depending on the material of your mounting surface, you may require different
screws and anchors than those supplied.
INSTALLATION
The dome camera is a fully integrated enclosure with camera and lens.
1. Bottom case
2. Camera base
3. Tilt adjustment
bracket
4. Inner liner
(Not present on
Do721R model
series)
5. Dome cover
6. Anti drop hook
1. Plastic Anchors
2. Flat Hand Screws
(Tapping Type)
Note: outdoor
screws come with
O-rings included.
Note: The Do-series
cameras come with
a large rubber gasket
to provide the seal
between the mounting
surface and the camera
base.
Figure 2.
Disassembling the camera
Figure 3.
Camera Surface Mounting
Applicable to the following models:
Do721, Do721R, Do721P, Do721RP
a
b
8
1. Conduit holes used for surface run power/video
connector
a. Side conduit hole (1/2”).
When using outdoors, sealant must be
used to maintain the IP67 status.
b. Top conduit hole (3/4”) (can also be used
for pendant mount).
When using outdoors, sealant must be
used to maintain the IP67 status.
2. Bottom case
3. Camera Base
4. Dome cover
5. Focus lever
6. Zoom lever
7. Video output connector
8. 24 VAC / 12 VDC power input connector (red
+, black -)
Figure 1.
Camera Parts
i3-TRNG-CAMS-
Do721-series-QuickGuide
.indd
Rev.
130130
