Teledyne Lecroy WaveSurfer 3000, Operator'S Manual, Page: 27 / 97

Operator's Manual
Turning On/Off Traces
Analog Trace
From the display, choose Vertical > Channel <#> Setup to turn on the trace. To turn it off, clear the Trace On checkbox
on the corresponding Channel dialog.
From the front panel, press the Channel button (1-4) to turn on the trace; press again to turn it off.
NOTE : The default is to display each trace type in its own grid automatically (e.g., Channels together, Zooms together,
Functions together).
Digital Trace
From the display, choose Vertical > Digital <#> Setup .
From the front panel, press the Dig button , then check Group on the Digital<#> trace dialog. Clear Group to turn off the
trace.
Other Traces
You can quickly create zoom or math traces without leaving the setup dialogs by touching the Zoom or Math shortcut
button at the bottom of the dialog.You can also use the front panel Zoom , Math , or Mem (ory) buttons to quickly create
traces.
Activating Traces
A trace descriptor box appears on the display for each enabled channel, digital, zoom, math, or memory trace. Touch
this box at any time to activate the trace; touch it again to open the setup dialog. A highlighted descriptor box indicates
the active trace to which all actions apply.
Inactive trace descriptor (left), active trace descriptor (right).
Although several traces may be open and appear on the grid, only one at a time is active. Whenever you activate a trace ,
the dialog at the bottom of the screen automatically switches to the appropriate setup dialog for that trace. The tab at the
top of the dialog shows to which trace it applies.
Active descriptor label matches active setup dialog tab.
923648 Rev A
21