Telect, Inc. • USA +1.509.926.6000 • 52.33.3836.37.52
www.telect.com • © 2010 Telect, Inc., All Rights Reserved, 126254-4 A0.1
Page 3-28
NOTE:
For service or warranty information, please visit the telect.com website, or email inquiries
to [email protected] and click on the “Support” tab, or phone us at 800-551-4567 (domestic
only) or 509-926-6000.
3.2 Panel Installation (All Except 1RU)
Prepare, mount, and insert modules and cable management rings in all panels in a rack before
cabling any panels in the rack.
1. If applicable, if you plan to pass fiber strands, cables, and/or tubing through the 1-½ in. (38.1
mm) diameter holes in the tops and bottoms of panels, see the notes below and then knock
out the applicable fire-abatement plugs covering these holes, as shown in Figure 30. Install
flexible edge protectors (or a standard grommet for 1½ in. holes) in place of plugs.
NOTES:
•
Avoid removing fire-abatement plugs on the top of the top-most and bottom of the bottom-
most panel.
•
You can knock out plugs when the panels are in place on the rack; however, plug removal
is easiest before racking the panels.
2. Install standard entry/exit split arcs and/or either standard isolation hooks kits or optional en-
try/exit arc kits at the front and/or rear corners of the panel.
Figure 30 - Removing Knockouts & Installing Plastic Grommets
Flexible Plastic Edge Protector
