SHDSL.EVB.4CH User Manual
Revision: 1.0.0, 2019-02-05
24/37
5
User Interfaces
There are two management versions available:
1. BSI - Basic Status/SHDSL Interface (P2 is needed) (more information in chapter 5.2),
2. CLI - Command Line Interface (P3 is needed) (more information in chapter 5.3).
The two different user interface versions can be activated via DIP switch 3:
•
On: CLI is active,
•
Off: BSI is active (more in information in Table 8).
5.1
Establish a Connection
SHDSL.EVB.4CH provides user interface via serial interface (UART) and Telnet interface.
For serial interface are two equal alternatives available: TTL compatible interface and
emulation via USB (see section 3.7). The baud rate is 115.2 kbaud/s with 8 data bits, 1 stop
bit and none parity. With a Terminal Emulation Software like PuTTY, TeraTerm and Minicom
or other VT-100 compatible software program you can establish a connection to the evaluation
board.
To establish a connection via the Telnet interface please use following settings: IPv4 address:
10.10.10.1 (default IP), Netmask: 255.255.255.0.
5.2
BSI - Basic Status/SHDSL Interface
The BSI interface provides a cyclic printout of SHDSL status to UART and / or USB only.
During startup you will see for example the following print out:
Start SHDSL.EVB.4CH bootloader (3.0-R2559) ...
Start application ...
-- Startup --
=======================================================
Boot-Ver#: 3.0-R2559
SW-Ver#: 3.0-R2569
PHY-Ver#: 1.1-2.1.0__001
IDC-Ver#: 2.1.0.0
Serial#: 0123.E60B.C44F.2007
Vendor: Teleconnect GmbH
Am Lehmberg 54 - 01157 Dresden - Germany
[email protected]
Copyright (c) Teleconnect GmbH 2013-2018.
All rights reserved.
=======================================================
