Telecom Behnke 5 Series, Instructions Manual, Page: 56 / 104

GB
56 www.behnke-online.com
Instructions series 5
GB
Configuration and Set-up
Code Parameter Confirmation
58
1. Voice message no. 1 (51-1) “Direct call activated.”
3. Voice message no. 3 (51-3) “Please hold the line.”
9. Voice message no. 9 (51-9) “Call from your intercom system.”
Making the following entry will result in these voice messages to
be played during a direct call:
58 1 [beep] 3 [beep] 9 [beep] #
In case the message “Direct call activated.” should not be played,
make the following entry:
58 0 [beep] 3 [beep] 9 [beep] #
70
Silent connection and call answering:
Default setting: 0
0 = activated
1 = deactivated
Via this configuration step, you may determine when the speaker
will be activated during calls from the device. In case silent
connection is activated, the signals indicating a connected call,
a busy line or error messages will not be played via the speaker.
Deactivating the silent connection option will result in the speaker
being activated upon device activation.
In case silent connection is activated, the device will wait for the
called party to pick up before a communication channel is enabled.
#
#
73
Label illumination: Default setting: 1
0 = deactivated
1 = activated
Turn label illumination on/off via this step. Requires an additional
15 V power supply.
#
#
900
Extended configuration: Default setting: 0
0 = disabled
1 = enabled
The following configurations may only be adjusted with enabled
extended configuration.
#
#
945
Debounce time: Default setting: 3
Debounce time buttons 1-3, alarm button
0 = 0 ms
1 = 128 ms
2 = 256 ms
:
9 = 1152 ms
This configuration step will set the debounce time for all buttons
(i.e. the amount of time a button needs to be pressed before it will
be recognised as an active button).
#
#
#
:
#