Telecom Behnke 5 Series, Instructions Manual, Page: 51 / 104

51 www.behnke-online.com
Instructions series 5
GB
Configuration and Set-up
4.2. Table of configuration step codes
Code Parameter Confirmation
00
Reset and return to default settings:
* * * *
Performing a reset will format the entire memory and all param-
eters will return to their default settings. Performing a reset will
take several seconds. During a reset, the device will produce a
high-pitched tone.
#
01
Change the security code: Default setting: 0 0 0 0
new code [beep] new code
The security code is a four-digit code. Please enter the new security
code twice. The default security code is: 0 0 0 0.
Please note: To prevent unauthorised changes in your configu-
ration, we strongly advise you to change your device’s security
code.
#
03
Answering a call: Default setting: 1
0 = manually by pressing a button
1 = automatically
#
#
04
Input delay for direct call buttons: Default setting: 0
0 = none
1 = 1 second
…
9 = 9 seconds
During this configuration step, it will take a couple of seconds
before the device will confirm a correct entry. Choosing this option
will result in a direct call button to be pressed for at least the
amount of time specified before connection of a direct call.
#
#
…
#
05
Connection interval: Default setting: 3
0 = unlimited (i.e. limited to a connection of up to 8 hours)
1 = limited to 1 minute
…
9 = limited to 9 minutes
After the connection interval has elapsed, the connection will be
terminated automatically.
#
#
…
#
06
Volume: Default setting: 7
0 = very low volume
…
9 = very loud volume
Via this configuration step, you may adjust the volume in full
duplex mode (standard mode).
#
…
#