Teleco Voyager Digimatic 50, Installation Manual And User'S Manual

Page: 11 / 24

Country Town HOT BIRD ASTRA ATLANTIC
13° EST 19° EST BIRD 3 5° WEST
ALBANIA Tirana 42 42 36
ALGERIA Algiers 46 44 47
Costantine 47 45 45
Oran 46 43 48
AUSTRIA Innsbruck 36 35 33
Salzburg 35 35 32
Vienna 35 35 31
BALEARICS Palma 44 42 44
BELGIUM Antwerp 31 30 31
Brussels 31 30 31
Gand 31 30 31
Liege 31 30 31
BULGARIA Burgas 39 40 31
Sofia 40 41 33
CZECH
REPUBLIC
Brno 33 34 30
Prague 33 32 30
DENMARK Copenhagen 27 27 25
EGYPT Alexandria 49 52 38
Cairo 50 53 38
FINLAND Helsinki 21 22 17
FRANCE Lyon 36 35 36
Marsille 39 37 38
Paris 36 35 36
Toulouse 38 37 39
GERMANY Berlin 30 30 28
Cologne 31 31 31
Hamburg 30 28 28
Munich 35 34 33
Stuttgart 34 34 33
Table of Elevation values for initial DSF80E setting up with Voyager systems
Instructions for DSF80E initial set-up with Voyager systems
Set-up operations should only be carried out once upon system installation. After completing
all the required connections, perform inclinometer
"ADJUSTMENT" to the vehicle on which
it is installed.
1) Check the
Adjustment Table to identify the correct dish angle for the selected satellite
pointing (e.g. HOT BIRD 13E) from the installation area (e.g. HOT BIRD from Florence =
39°).
2) Switch on the DSF80E device by setting the power switch to
ON and then select the
satellite to point (e.g. HOT BIRD ) by pressing the SAT button. Adjust the VOYAGER
elevation and rotation settings to point the satellite as required and optimise pointing until
the
LEVEL indicator shows the maximum number of burning LEDs and the SAT OK LED
lights up.
3) The
ELEVATION display unit of DSF80E will show a figure describing your dish angle.
This figure must match the figure shown in the Adjustment Table (for instance, in Florence,
the angle value that can be found in the table is 39°). If the display unit reading does not
match the adjustment table value, the device must be reset.
4) To reset the device, insert a small hard tip (e.g. the end of a metal staple) in one of
the 2 holes next to
"Adj" then press repeatedly until the display unit reads the correct
angle value (39°). The button inside the left-hand hole will decrease the value, while the
button inside the right-hand hole will increase the value.
5) The DSF80E device is now ready to function and the display unit will always show the
dish angle actual ‘absolute’ value even if the vehicle is not levelled.
10