14
Warnings
IMPORTANT! READ THIS INSTRUCTIONS CAREFULLY BEFORE INSTALLING AND
COMMISSIONING THE PRODUCT. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PRODUCT INSTALLATION
The product at issue must be installed, commissioned and maintained only by licensed and authorised people, respecting
the laws concerning the electrical installations. Not conforming installations, wrong adjustments or product alterations may
cause fire, electric shock, or personal injuries. The manufacturer is not responsible for any damage due to wrong installation
or improper use.
Attention:
at the power-on the device resumes the status it had before the turning-off.
MOUNTING LOCATION AND MODALITY
The product must be mounted applying the following indications carefully:
• it must be
fixed on surfaces which cannot be damaged by the high temperature.
• it must be
placed in a well ventilated location. It cannot be hermetically closed.
• it must be
fixed vertically, with cable glands downward.
• connection cables
must be
protected against any accidental impacts, using proper pipes.
• do not cover
the product.
• do not
use or store flammable materials close to the product.
ELECTRICAL CONNECTIONS
All the connections must be rated for a single-phase 110/230Vac power supply, with the relative Earth connection. For the
disconnection from the power line, use an all-pole switch with contacts having a dimension of at least 3,5mm. Arrange
all
the necessary safety devices
and use only materials complying with the standard of electrical installations. Signal and
power voltage wiring (110/230Vac) must be separated one from the other. The cable must have a section properly rated
according to the load connected and a nominal temperature range (T) up to 90°C. The following table reports (roughly) the
resistance values and the maximum current of a copper wire, according to its length:
Section (mm2)
R (ohm/Km) Max. current (A)
1
19.5
5
1.5
13.3
10
2.5
7.98
16
WARNING: If any cable is damaged, it must be immediately replaced by a qualified person in order to avoid any hazard.
SAFETY INFORMATION
This appliance is not intended for use by people (including children) with reduced physical, sensory or mental
capabilities, or not properly informed about the product’s characteristics or the possible hazards it can cause.
Children should be carefully supervised when they are in the area of the product. Do not touch the electronic board
with wet hands, any metallic or flammable objects. Do not operate in the high voltage area of the electronic board,
when it is supplied. Do not touch the heatsink, for at least 15 minutes after the switching off of the product. Use the
product only in combination with devices which can guarantee a safe extended time functioning.
The radio signal
reception of the device could be disturbed by the presence of electrical disturbances being transmitted by
other appliances working on the same frequency or if the product is somehow shielded by metal parts.
PRODUCT DISPOSAL
At the end of this product’s useful life, it must not be disposed of as domestic waste, but must be taken to a collection
centre for waste electrical and electronic equipment. It is the user’s responsibility to dispose of this appliance through the
appropriate channels at the end of its useful life.
Hereby Teleco automation s.r.l. declares that the product complies with the essential requirements and other relevant
provisions, established by the Directive 1999/5/EC. The declaration of conformity can be consulted on the web site:
www.telecoautomation.com/ce.
In the view of a constant development of their products, the manufacturer reserves the
right for changing technical data and features without prior notice.
Summary of Contents for TVDMM868A05
Page 16: ......
