11
1.13 - Copying the function of a transmitter to a new transmitter
1- Press the button
P3.
The enabled receiver
sounds continuously.
2- Within 5 sec. press a button of the
already memorized transmitter
of
which the function has to be copied.
The buzzer will interrupt the sound for
1 sec., and then carry on for 5 sec.
3- During the sound press the
button of the
new transmitter
which has to be memorised; the
memorization is indicated by the
intermittent sound of the buzzer.
Function available
for all type of
transmitters
Attention: when a 4 or 7/42 channel transmitter is copied, also its preset levels will be copied
into the new one.
The button P3 is located inside the transmitter (see transmitter manual).
The new transmitter will have the same functions of the transmitter used for its memorization.
Press
P3
Press
Press
c. The 4/7/42 channel transmitter is associated to more than one output as MASTER device and
there are also transmitters associated to the single output.
MASTER
(4/7/42 channels)
SINGLE OUTPUT
TRANSMITTER
(any type)
1- Press the button relative
to the scene to modify. All
the output associated to this
transmitter will turn the load
on at the preset value.
Press
2- Adjust the new value with the
transmitter associated ONLY to the
desired output. Use the button with
function Dim + and Dim -, or turn
the output ON/OFF.
Single output tx
(1 or 2 or 3 or 4)
3- Hold down
CH4 or CH7
button for 5 sec. At the end
only the load connected to the
selected output will turn on at
the new value.
5 sec. press
5 sec. press
CH1
CH2
CH3
CH4
CH7
CH1
CH2
CH3
CH4
7/42 CH.
4 CH.
OUT
1
OUT
2
OUT
3
OUT
4
1
2
3
4
Summary of Contents for TVDMM868A05
Page 16: ......
