Teleco Flat Sat Classic Smart 65, Installation And Operation Manual

Page: 21 / 32

Troubleshooting for Kit with control unit and TELECO TV TY2
If the control unit does not turn on by pressing the button (1) check the following:
a) Are the RED and BLACK cables properly connected to the battery? The RED cable must
be on the + pole, the BLACK cable on the - pole. Should you have mixed up the cables,
first disconnect them, replace the safety fuse on the back of the control unit using a similar
one (5 A), then re-connect the RED and BLACK cables properly to the battery.
b) Is the engine of your vehicle running? Turn it off, since this means the safety system
which keeps the antenna down is operating.
c) Have the connections been properly made? Check the connections in the installation
manual.
d) Are the remote control batteries properly charged?
e) Is the control unit MIR visible and are you directing the remote control towards the MIR?
f) Is the TV on?
If the control unit turns on by pressing the button (1) but the TV does not:
a) Make sure that the TV is part of the Kit and that the connections described in the installation
manual have been made properly.
b) Is the TV on?
If the Flat Sat Elegance Smart has not found the satellite after a complete search, check
the following:
a) Is the view towards the South free from any obstacle?
b) Is the place you are at within the reception area (footprint) of the satellite you have
chosen?
c) Is the cable connecting the LNB to the antenna firmly fastened? It could have been ripped
off or come loose because of contact with an unexpected obstacle.
d) Are all the connections on the control unit properly set up? Make sure that the white coax
cable coming from the outside powered unit is connected to the LNB connector of the
control unit.
If, when the satellite search is over, the TV screen is black, check the following:
a) Is the RCA-Mini AV cable connected between the Video TV of the control unit and
the Mini-AV IN of the TV? Connect it as indicated in the Installation manual.
b) Is the TV off? Turn it on by pressing the button (2) on the remote control,
If, when the satellite search is over, the message “No Signal” is displayed on the TV
screen or if the TV screen is jammed, check the following:
a) Have you connected the RECEIVER output of the control unit to the DVB-S2 input of the
TV via a coax cable? Connect it as indicated in the installation manual.
20