Tele Radio TG-R4-26, Installation Instructions Manual

Page: 37 / 66

The top LED flashes (green when the battery capacity is good, red when the battery capacity is poor)
when in menu mode.
9. Go to [Register].
10. Select an empty slot and confirm by pressing the left start button. The display shows [Registering] .
11. When the receiver has found the transmitter, all relay LEDs flash red. The display shows [Confirm
on RX].
12. Press the receiver Select button. Function LEDs 1-7 flash 3 times. The relay LEDs go off.
13. All Function LEDs light for approx. 1 second. The transmitter is now registered in the receiver. The
transmitter turns off.
14. If registering fails, the display shows [FAILED]. The transmitter turns off.
ERASE
WARNING! If a transmitter is lost or becomes seriously damaged, it is possible to erase it from the
receiver. We do not recommend this way. Contact your representative for assistance.
NOTE! If the transmitter already have receivers registered, we recommend that you erase all receivers
from the transmitter before starting the replacement. The receiver will automatically be stored in the
same position as it was stored in the old transmitter. If this position is not available, the replacement will
not take place.
1. Make sure that the stop button is pressed.
2. Twist and pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor).
3. Press the right start button. Keep pressed.
4. Press the stop button.
5. Release the right start button.
The top LED flashes (green when the battery capacity is good, red when the battery capacity is poor)
when in menu mode.
6. Go to [Erase].
7. Select by pressing the left start button.
8. Select a receiver. Confirm by pressing the left start button. The display shows [Erasing] while the
process is ongoing.
If the erasing fails, the display shows [FAILED]. The transmitter turns off.
If the erasing succeeds, the display shows [OK]. The transmitter turns off.
- 37 -