; -- DHCP Server Configuration --
subnet subnetea 0 network 172.24.0.0 255.255.0.0
subnet subnetea 0 bootfile fwethant.img
subnet subnetea 0 next-server 172.24.78.29
subnet subnetea 0 router 172.24.78.29
;
enable
;
host eth-ant 0 ethernet 00-a0-26-53-29-02
host eth-ant 0 fixed-ip 172.24.78.31
host eth-ant 0 option 43 asc antenna&sipport=5060&localphone=607081119
Router 2:
protocol dhcp
; -- DHCP Configuration --
server
; -- DHCP Server Configuration --
subnet subnetea 0 network 172.24.0.0 255.255.0.0
subnet subnetea 0 bootfile fwethant.img
subnet subnetea 0 next-server 172.24.78.30
subnet subnetea 0 router 172.24.78.30
;
enable
;
host eth-ant 0 ethernet 00-a0-26-53-29-03
host eth-ant 0 fixed-ip 172.24.78.32
host eth-ant 0 option 43 asc antenna&sipport=5060&localphone=607326598
4.2 LEDs
The device has several LEDs and their meaning is as follows:
LED
STATUS
DESCRIPTION
POWER
ON/OFF
When this is lit up, the device is receiving power.
WWAN
OFF
Error in the WWAN module. 3G communications are not possible.
Flashing Green (slow) The SIM card hasn’t been detected or the PIN is incorrect.
Flashing Green (fast)
The module cannot register in the network.
Steady Green
Communications at the PPP layer.
Ethernet Connector
ON/OFF
The left hand LED lights up in yellow when there is link level and the
right hand one flashes in green when there is data communication.
STATUS
Steady Red
Error in the WWAN module. 3G communications are not possible.
• Check that the module is correctly connected.
• Check that it has the appropriate software.
• Look to see if the WWAN LED is lit up.
Flashing Red
The WWAN module is operating correctly but the device hasn’t got
an IP address yet.
• Check the status of the Ethernet connector LEDs.
• The device has access to the DHCP server.
• Follow the instructions given in the "Monitoring" section.
Flashing yellow
The device has received the IP address but hasn’t managed to es-
4 Appendix
Teldat S.A.
28
Teldat-3Ge Quick Guide
