Fig. 23:
The WLAN LED flashing
• After about 15 seconds, the WLAN LED goes out and the DSL LED lights up (see
on page 16). At this point
release the reset button.
Fig. 24:
WLAN LED goes out and the DSL lights up
• Wait for a few seconds until the device completes start up. If you have a local console connected to the CONF.
port, you can see that the device has paused start up in the BIOS menu (>> prompt):
CFE version 1.0.37-102.9-01 for BCM96358 (32bit,SP,BE)
Build Date: Fri Dec
4 12:10:54 CET 2009 (jsirodey@orion)
Copyright (C) 2000-2008 Broadcom Corporation.
Parallel flash device: name AM29LV320MT, id 0x2201, size 16384KB
CPU type 0x2A010: 300MHz, Bus: 133MHz, Ref: 64MHz
CPU running TP0
Total memory: 67108864 bytes (64MB)
Boot Address 0xbe000000
*** Break into BIOS menu ***
Board IP address
: 192.168.1.1:ffffff00
Host IP address
: 192.168.1.100
Gateway IP address
:
Run from flash/host (f/h)
: f
Default host run file name
:
Default host flash file name
:
Boot delay (0-9 seconds)
: 3
Boot image (0=latest, 1=previous) : 0
Board Id (0-0)
: 96358C1PL
Number of MAC Addresses (1-32)
: 4
Base MAC Address
: 00:a0:26:6e:00:58
PSI Size (1-64) KBytes
: 24
Main Thread Number [0|1]
: 0
DHCP running
*** Press any key to stop auto run (3 seconds) ***
Auto run second count down: 0
Booting from latest image (0xbe160000) ...
Code Address: 0x80010000, Entry Address: 0x80330000
Booting version 10.08.01
Decompression OK!
Entry at 0x80330000
Closing network.
Closing DMA Channels.
Starting program at 0x80330000
CIT software version: 10.08.01
Current software license: 22 48
1 Installing the Router
Teldat S.A.
16
Teldat C1+LS Router
