OFF: No data in the interface.
GREEN: Intermittent Traffic in the interface.
1.4 RST Pushbutton
The Teldat C1+LS router has a pushbutton labeled RST that allows you to ignore the current configuration and es-
tablish the default configuration.
The RST pushbutton is located on the rear of the Teldat C1+LS router. It is protected in such a way that it is only ac-
cessible from the outside by using a tool with a sharp edge to press it.
Fig. 18:
RST Pushbutton
This pushbutton should not be handled by the user other than when it’s necessary to ignore the current configuration
and establish the default configuration. This forces start up in either BOOT mode to permit updating from BOOT, or
in BIOS mode in order to relicense and delete the configuration files.
1.4.1 Procedure to ignore the current configuration and to establish the default
configuration
Follow the steps below when you have to reject the whole configuration of the device (for instance, if you cannot re-
member the password).
• Turn off the device through the ON/OFF switch.
• Using a sharp object, press the RST pushbutton and hold it down.
• Turn the device on with the ON/OFF switch.
• Wait until the WLAN LED begins to flash (see
on page 12) and release the RST pushbutton.
Fig. 19:
Once the WLAN LED is flashing you can release the pushbutton
• Once the pushbutton has been released, the WLAN LED turns off and the process to boot the device with the de-
fault configuration begins.
Note
When the RST pushbutton is released, a message similar to the one shown below will appear on the
configuration console.
1 Installing the Router
Teldat S.A.
12
Teldat C1+LS Router