Chapter 3 Configuration
The Teldat 4Ge can be used to connect any Teldat, Cisco or third-party router to a 4G network. The following sec-
tions describe how to configure the router in these cases.
3.1 Configuring a Cisco router
Connecting a Cisco router to a cellular WWAN via the Teldat 4Ge is done through an Ethernet subinterface with
VLAN 463.
The following configuration example shows how to connect a Cisco router via the Teldat 4Ge:
Current configuration: 1634 bytes
!
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname Router
!
boot-start-marker
boot-end-marker
!
logging message-counter syslog
enable secret 5 $1$Shh8$vJXxVHzI4oGPou3hFCq7E0
enable password cisco
!
no aaa new-model
!
!
dot11 syslog
ip source-route
!
!
ip dhcp pool 4Ge
host 2.2.2.2 255.255.255.0
client-identifier 7465.6c64.6174
option 43 ascii “antenna&apn=internet.es&pin=1016&ntps=192.168.215.115&usr=monitor&pwd=teldat"
default-router 2.2.2.1
!
!
ip cef
no ipv6 cef
!
multilink bundle-name authenticated
!
!
archive
log config
hidekeys
!
!
interface FastEthernet0/0
ip address 192.168.215.119 255.255.252.0
ip nat inside
iip virtual-reassembly
duplex auto
speed auto
!
interface FastEthernet0/1
ip address 2.2.2.1 255.255.255.0
ip nat inside
ip virtual-reassembly
Teldat S.A.
3 Configuration
Teldat 4Ge
7
