24
Tmedia System Installation Guide for TMG3200
2.7
Powering Down
Powering down the TMG3200 requires that the Linux embedded host be shut down. In order to do this,
you must connect to the management interface using SSH, and enter:
shutdown -h now
Note
As an alternate method to this procedure, refer to Section 2.6.4 “Verifying the LED Status
Indications” on page 23, to power down the TMG3200 with the reset button.
DO NOT TURN OFF
the power to the
TMG3200 using the power switch located at
the rear, unless the Linux host has been
properly shut down beforehand, using the
reset button display, or manually using the
shutdown command. Allow enough time for
the Linux host to shut down before turning the
power to the TMG3200 off (e.g. 1 min). Be
aware that the shutdown procedure of the unit
is logged and traceable for support and
warranty purposes.
