
Operating Manual
Telco Multimeter
KE2500
KURTH ELECTRONIC www.kurthelectronic.de [email protected]
9
Line Multimeter
1.1 Voltage
The purpose of this study is to measure the direct and the
alternating voltage: in the AC range only the alternating
voltage is displayed, the direct voltage and the rms value (DC
+ AC) are displayed in the DC range.
Measuring method
Connect the wires to be measured and the shield of the cable.
Select the
Voltage
mode and press
SEL
. The measurement is
then started automatically. The results of the alternating and
direct voltage are displayed numerically in volts and the
frequency in Hz.
With
F1
, the min / max values can be switched on or off for
easier assessment. Under
F2
Probe the measurement points
can be selected from the differential voltage measured
between two cores of a pair of conductors (A-B) and the
common-mode voltage measured between a pair of
conductors and the ground (A-GND, B-GND). With
F3
, the
measuring ranges can be switched between DC (DC voltage)
and AC (AC voltage) and AC TP (AC voltage with low-pass
filter> 200 Hz). Under
F4
Term, the input resistance is reduced
from 10 MW to 120 kW to measure the actual voltage.
Safety note:
The measured voltage must not exceed the value of 600 V
for phase to ground or phase to phase.
Voltage
Voltage
DC:
AC/DC:
AC:
Probe
Probe
0,005 V
0,023 V
0,123 V
Date / Time
Date / Time
f:
f:
49,98 Hz
49,98 Hz
A - B
A - B
Area
Area
AC
DC
Term
Term
None
None
A - B
A - GND
B - GND
A - B
A - GND
B - GND
AC
AC LP
DC
DC
AC
AC TP
None
120 k
W
None
120 k
W
min: 0,003 V
min: 0,118 V
max: 0,005 V
max: 0,124 V
On
Off
On
Off
min/max
min/max
On
An