www.tekvox.com
TekFlex-16
79201 User Manual
5.3.2 RS232 Communication Commands
1.
Case insensitive.
2.
In following
commands, “[”and “]” are symbols for
easy reading and do not need to be typed in
actual operation.
3.
Type in the complete commands including ending symbol
“.”
or “
;
”.
4.
For input/output channels 1~9 in the commands, type in 01~09 instead of 1~9.
5.
After sending command
“%0911.”
to restore factory default, wait for approximately 10 seconds
before rebooting the device. Otherwise, the restoration may fail, and it will prompt
“Default
failed, please try again!”
in the feedback.
Communication Protocol
: Baud rate: 9600; Data bit: 8; Stop bit: 1; Parity bit: none
Command
Description
Feedback
System Command
/*Type;
Inquire the model
TekFlex-16
/%Lock;
Lock the front panel buttons
System Locked!
/%Unlock;
Unlock the front panel buttons
System Unlock!
/^Version;
Inquire the firmware version
VX.X.X
/:MessageOff;
Turn off the feedback from the com port. It
only
shows “switcher OK”.
/:MessageOff;
/:MessageOn;
Turn on the feedback from the com port.
/:MessageOn;
Operation Command
Undo.
Cancel the previous operation.
Undo Ok!
Demo.
Switch to the “demo” m
ode, 02->01, 2->2,
3-
>3 … and so on.
Demo Mode
AV: 02->01
……
[x]All.
Transfer signal from Input [x] to all outputs
02 To All.
All@.
Switch on all the outputs
All Open.
[x]@.
Switch on output [x]
02 Open.
All$.
Switch off all the outputs
All Closed.
[x]$.
Switch off output [x]
01 Closed.
