www.tekvox.com
MV41+
79141-MV User Manual
8. RS232 Control
To control the switcher using RS232 commands, connect the RS232 port of the switcher to a control
device (PC, TekMonitor, etc.) with an RS232 cable. The command lists in the following sections are
used to control the switcher. If using a PC to send RS232 commands, the Pc must have RS232
control software installed.
After installing the RS232 control software, set the COM port’s parameters according to the following
in order to send RS232 commands to the switcher:
Baud Rate
: 9600
Data Bit
: 8
Stop Bit
: 1
Parity Bit
: None
Note
:
•
In the following commands, “[“ and
“]” are symbols included to make reading the commands
easier, and do not need to be typed when sending commands
•
All commands are case-sensitive
•
Unless otherwise stated, the ending mark of all commands is “<CR><LF>”
