Getting Started
Module Installation and Removal
The following procedures describe how to install and remove modules from the
TG700 mainframe. A screwdriver with a #1 Phillips tip is the only tool you need
to install or remove a module.
CAUTION.
To prevent damage to the mainframe and module, always remove the
power cord before installing or removing a module.
Preventing Component
Damage
CAUTION.
Electrostatic discharge (ESD) can damage components on the module
and mainframe. To prevent ESD or other component damage, follow the
guidelines below when installing, removing or handling a module.
Wear a grounded antistatic wrist strap to discharge the static voltage from
your body while installing or removing modules from the TG700 mainframe.
Transport and store modules in a static-protected bag or container.
Do not slide the module over any surface.
Handle modules as little as possible.
Do not touch module components or connector pins.
Do not use any devices capable of generating or holding a static charge in the
work area where you remove, install, or handle modules.
Avoid handling modules in areas that have a
fl
oor or work-surface covering
capable of generating a static charge.
Do not remove the module circuit board assembly from the shield. The
shield is an important stiffener which prevents damage to surface-mount
components.
TG700 TV Signal Generator Platform User Manual
1–9
Summary of Contents for TG700
