Reference
3-26
ST2400A SDH Test Set User Manual
If the character being edited on the second row is less than 0x20 hex or greater than 0x7F hex,
the character will be displayed as a filled in box in the center of the field, the correct value will still
be displayed in the “HEX=” field.
16 BYTE <EDIT> CLR HEX=54
TEK ST2400A CRC=F4
When 64-byte trace is selected, 62 editable bytes of 64-byte trace are set to bytes stored in 64-
byte trace memory. Last two bytes are set to <CR><LF>. Factory default trace is “Tek
When CLR is selected, 62 editable bytes of 64-byte trace are cleared to nulls (hex 00), and
<CR><LF> is placed in last two characters.
When trace characters are selected, left arrow, right arrow, INC, DEC, and ENTER are used to
navigate trace and edit characters. If trace contains non-printable ASCII characters, those
characters are displayed as a filled in box.
When cursor is in right-most character position and right arrow key is pressed, trace is shifted left
so character and cursor – previously in right-most character position – now appear in left-most
character position, with 21 following characters displayed in remaining positions. As shown
below, arrow indicator is displayed in left-most and/or right-most display position when preceding
or following trace characters are available to be displayed by scrolling left or right:
ß
ß
64 BYTE <EDIT> CLR HEX=54
à
à
ST2400A
Summary of Contents for ST2400A
