Getting Started
1-6
ST2400A SDH Test Set User Manual
•
Complete Remote Control
RS-232 and GPIB ports, and standard printer interfaces
LabView, LabWindows CVI, and HP Vee
LAN (using LAN to GPIB converters)
ST2400A GUI Front Panel Utility
•
Standard tributary interfaces
STM-1e 155 Mb/s electrical
STM-1 155 Mb/s optical
STM-4 622 Mb/s optical
•
Interface to Regenerator Section Terminating Element and Multiplexer Section Terminating
Element and other test equipment
With firmware version 5.0 (Option 42), the following new features are added to capabilities of the
ST2400A:
•
Payload bit error injection/ B3 Injection on the TX side (TSE)
•
B3, Path-REI, Payload bit error count measurement on the RX side (TSE ES, SES (SDH
only)
•
Alarm signal status (RX) - Path RDI, Loss of Pointer, Path AIS, Path REI
•
Path Overhead Monitor (RX) - Displays value of following bytes: J1, B3, C2, G1, F2, H4,
Z3/F3, Z4, N1
•
For the path overhead, C2 byte added at TX (Path Signal Label C2)) - Identifies High Order
Path Label Unequipped and High Order Path Label Mismatch. C2 byte can be set to any
value from 0x00 to 0xFF.
•
B3 Path Analysis/ J1 Path Trace (displayed as ASCII text).
•
Tx Patterns. PRBS 2-31
-1
and 2-31
-1
Inverted; Fixed (00 to FF) (TX mode button)
•
Pointers (Read-only menu under RX Trib button). Pointer Value displayed (0 to 782). Pointer
Measurement Counts for Positive Pointer Justifications, Negative Pointer Justifications, New
Data Flag (NDF)
•
Extended capability of View History button (more LEDs - virtual LEDs)
•
APS Switch Time measurement (LOF, LOS durations). APS testing can be performed by
causing protection switch via control of K1/K2 bytes and then displaying time to restore frame
synchronization. Highly-accurate LOF timer enables this test to be performed with
<1 ms resolution.
•
RX mapping (PRBS 2-23
-1
and 2-23
-1
Inverted; PRBS 2-31
-1
per ITU-T O.151 and 2-31
-1
Inverted per ITU-T O.181, User-defined byte 0x00 to 0xFF) (RX Channel Selection, under
RX Trib button)
NOTE:
Option 42 must be purchased for B3 capabilities (To determine if a TX board is B3
capable, the return value from the remote command "tx_brd_rev" must be greater than or equal to
35. To determine if an RX board is B3 capable, the return value from the remote command
"rx_brd_rev" must be greater than or equal to 9).
Summary of Contents for ST2400A
