Reference
Figure 26: Recommended trace routing on inner or secondary surface layer (primary
layer pads not shown)
Clock Cable Three-Pin
Connector
If you intend to use a midbus probe and a clock cable, a three-pin micro-terminal
strip connector must be installed on your SUT. A non-intrusive clock cable
(Tektronix part number, 672-6285-00) has two SMA connectors on one end
(+ and –), and a small circuit board with a mating three-pin connector on the other.
Only one connector is needed, even if more than one TLA7S08 or TLA7S16
module is used. In this case, a “jumper” clock cable with SMA connectors on
each end (+ and –) can connect the two modules and share the clock signal.
Tektronix suggests installing the following three-pin connector (or similar):
Through hole: Samtec® TMS 103-02-S-S
(1 x 3, 0.05 center spacing)
Surface mount: Samtec® FTR 103-02-S-S
(1 x 3, 0.05 center spacing)
28
P6700 Series Serial Analyzer Probes Instruction Manual
Summary of Contents for P6700 Series
