© Tait Limited November 2012
www.taitradio.com
402-00092-00
T02-00034-ABAA
Telemetry Cable/Horn Relay
Installation Instructions
Introduction
The T02-00034-ABAA cable can be used to
connect to the input and output lines of the
auxiliary connector of TM8000 and TM9000
mobile radios.
The cable also provides a line for ignition sense
and a relay driver for switching a 12V relay.
Notice
The radio does not meet the IP54
protection standard once the bung covering the
radio’s auxiliary connector has been removed.
Notice
The cable may not be suitable for use in high-temperature environments such
as the engine compartment.
Hardware Configuration for Ignition Sense
The radio hardware link LK2 (on the top-side of the radio’s main board) must be fitted for
ignition sense operation. The following table describes the configuration options.
LK2 is fitted by default.
Configuration of hardware links for ignition sense
Link required
Voltages required for T02-00034-ABAA
LK2 in
(factory default)
Ignition signal
≤
0.9V (or floating) = off
Ignition signal
≥
5V = on
Ignition-sense compatible with 24V vehicular systems (34V max.)
