Reference
P6434 Probe Instructions
37
Elastomer
Ledge
Tweezer
Elastomer
Ledge
Gold plated
contact pads
Elastomer
slot
Figure 27: Positioning the elastomer connector
5.
Place the circuit board attached to the pin 1 cable into the back (cable side)
of the board holder as shown in Figure 28.
6.
Press the front (connector side) of the circuit board attached to the cable
down until it snaps into place in the board holder.
Align the back edge first, and then
snap the front edge into place
Board holder
Pin 1 indicator
Pin 1 cable
Figure 28: Positioning the circuit board in the probe
7.
Turn the probe over and repeat steps 4 through 6 for the pin 38 side of the
probe.