Tektronix LE160, Technical Reference Manual

Page: 12 / 30

Australia / New Zealand
Declaration of Conformity
– EMC
Complies with the EMC provision of the Radiocommunications Act per the
following standard, in accordance with ACMA:
■ CISPR 11:2003. Radiated and conducted emissions, Group 1, Class A, in
accordance with EN 61326- 1:2006.
Australia / New Zealand contact.
Baker & McKenzie
Level 27, AMP Centre
50 Bridge Street
Sydney NSW 2000, Australia
Safety compliance
This section lists safety and compliance information.
Equipment type Test and measuring equipment.
Safety class Class 1 – grounded product.
Pollution degree
description
A measure of the contaminants that could occur in the environment around and
within a product. Typically the internal environment inside a product is
considered to be the same as the external. Products should be used only in the
environment for which they are rated.
■ Pollution Degree 1. No pollution or only dry, nonconductive pollution
occurs. Products in this category are generally encapsulated, hermetically
sealed, or located in clean rooms.
■ Pollution Degree 2. Normally only dry, nonconductive pollution occurs.
Occasionally a temporary conductivity that is caused by condensation must
be expected. This location is a typical office/home environment. Temporary
condensation occurs only when the product is out of service.
■ Pollution Degree 3. Conductive pollution, or dry, nonconductive pollution
that becomes conductive due to condensation. These are sheltered locations
where neither temperature nor humidity is controlled. The area is protected
from direct sunshine, rain, or direct wind.
■ Pollution Degree 4. Pollution that generates persistent conductivity through
conductive dust, rain, or snow. Typical outdoor locations.
Compliance Information
viii LE160 & LE320 Specifications & Performance Verification