Run application software
Run application software
Each application is available for ten free trials on your instrument. These applications provide application-speci
fi
c
measurement solutions. Some examples are described below. Additional packages may be available. Some applications
may not be available on your instrument. Contact your Tektronix representative or visit our Web site at www.tektronix.com
for more information.
Use
DDRA
Memory Bus Analysis to automatically identify DDR1, LP-DDR1, LP-DDR2, LP-DDR3, DDR2, DDR3,
DDR4, DDR3L, GDDR3 and GDDR5 read and writes.
Use
DJA
DPOJET Jitter and Eye Diagram Analysis, Advanced to reliably measure complex clock, digital, and serial data
signals. DPOJET Essentials included standard with all models.
Use
D-PHY
for MIPI D-PHY Transmitter debug, characterization and compliance testing (requires option DJA).
Use
DP12
Display Port Compliance Software to validate your IC, motherboard, and graphics card designs.
Use
DVI
Compliance Test Solution Software for DVI physical layer compliance testing.
Use
ERRDT
Frame and Bit Error Rate Detector to detect errors in high speed serial standards (requires option ST6G).
Use
ET3
to perform 10/100/1000 Base-T Ethernet compliance testing.
Use
HT3
HDMI Compliance Test Software for HDMI compliance testing for
≥
4 GHz models.
Use
HT3DS
HDMI Direct Synthesis for HDMI 1.4 (requires HT3) for HDMI analysis.
Use
LT
Waveform Limit Testing to compare an acquired waveform to tolerance boundaries that you set.
Use
MOST
Essentials for electrical compliance and debug testing for MOST50 and MOST150.
Use
MTH
Communication Mask Testing Software for mask compliance testing on
≥
4 GHz models.
Use
MTM
Communication Mask Testing Software for mask compliance testing on <4 GHz models.
Use
PCE3
PCI-Express compliance test for Gen3. Used with DPOJET.
Use
PCE
compliance test for Gen1 and Gen2. Used with DPOJET.
Use
PWR
Power Measurement Software to quickly measure and analyze power dissipation in power supply switching
devices and magnetic components.
Use
SDLA64
Serial Data Link Analysis Visualizer to emulate the serial data channel, de-embed a
fi
xture, and add or
remove transmitter equalization.
Use
SR-810B
to enable serial triggering and analysis of 8B/10B signals.
Use
SR-AERO
for MIL-STD-1553 Serial Triggering and Analysis.
Use
SR-AUTO
for Serial Triggering, debugging, decode and Analysis of CAN, LIN, and FlexRay signals.
Use
SR-COMP
to enable serial triggering and analysis of RS-232/422/485/UART signals.
Use
SR-DPHY
for MIPI-DSI1 and MIPI-CSI2 serial analysis.
Use
SR-EMBD
to enable serial triggering and analysis of I
2
C and SPI signals.
Use
SR-ENET
for serial analysis of Ethernet signals.
Use
SR-PCIE
Serial Data Compliance and Analysis (requires ST6G for serial triggering).
Use
SR-USB
to enable serial triggering and analysis of USB2.0 and USB3.0 signals.
166
MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series User Manual
