Operation
Use the Clock Recovery instrument with a Tektronix BERTScope Analyzer
This section provides information on using the Clock Recovery instrument with a Tektronix BERTScope Analyzer.
The Clock Recovery instrument can be connected to a Tektronix BERTScope Analyzer through a USB cable, allowing full
control of the instrument through the BERTScope Analyzer touchscreen user interface.
The following setup is one of many ways of connecting the instruments. Your system con
fi
guration will vary. The following
steps are provided as guidelines for connecting the Clock Recovery instrument to a Tektronix BERTScope Analyzer.
Refer to the connection diagram as needed.
Figure 5: Connecting the Clock Recovery instrument to a Tektronix BERTScope Analyzer
1.
Connect a USB cable from the rear of the Clock Recovery instrument to the BERTScope Analyzer.
2.
Connect the Clock Recovery data input connectors to the BERTScope Analyzer Pattern Generator data output
connectors.
3.
Connect the Clock Recovery data output connectors to the BERTScope Analyzer data input connectors.
4.
Connect the Clock Recovery clock output to the BERTScope Analyzer clock input.
5.
Power on the BERTScope Analyzer and then the Clock Recovery instrument.
12
CR125A, CR175A, CR286A Quick Start User Manual
Summary of Contents for BERTScope
