Operating Procedures
AWVG1 Wideband Video Generator User Manual
2- 11
NOTE
.
Changes to certain parameters cause changes to other parameters. To
return all values to their state when the Video Parameters window was opened,
touch
Reset
on the display.
4.
Enter a value using the Navigation knob or keypad. This will adjust the
selected parameter for the currently selected test signal.
5.
Sync Amplitude and Burst Amplitude must be set to 0% or 100%.
6.
For horizontal sweep and field sweep signals, set the sweep parameters
(Sweep Amplitude, Sweep Start Freq and Sweep Stop Freq).
7.
Horizontal sweep signals can have adjustable markers. To change marker
settings, use the Navigation cursor keys (up/down arrows) to move to the
desired marker and press the
Select
key to select the marker. Use the knob or
keypad to set the frequency. Touch the
Marker X
icon (X represents the
number of the currently selected marker) to enable or disable the marker.
NOTE
.
When two or more markers overlap, only one marker will appear on the
waveform; the others will be blanked.
8.
Field sweep signals do not support adjustable markers. However, some field
sweep signals have fixed markers. You can alter the marker frequencies by
changing the sweep start and stop frequency. This is because the markers are
at 1/6, 2/6, 3/6, 4/6, and 5/6 of the total sweep. For example, start with a
field sweep signal that has a 0 to 30 MHz sweep and markers at 5, 10, 15,
20, and 25 MHz. If you change the sweep stop to 6 MHz, the markers will
be at 1, 2, 3, 4, and 5 MHz.
9.
When all desired parameters are set, touch
Quit/Save
. If you made changes,
a popup menu asks you to select
Save As
or
Quit
.
10.
Touch
Save As
. A text entry window appears, showing the current signal
name preceded by an underscore. (All user-defined signals are preceded by
an underscore, and you cannot delete it.)
Summary of Contents for AWVG1
