Tektronix AWG5UP 11, Instruction Manual

Page: 16 / 20

Installation Instructions
6
AWG5UP 11 Instructions Manual
.
.
Cabinet removal You will need a screwdriver with a size #2 Phillips tip.
1. Remove the six screws at the rear of the cabinet which secure the two feet.
2. Grasp the left and right edges at the rear of the cabinet.
3. Pull upward to slide the cabinet off the generator. Take care not to bind or snag
the cabinet on the internal cabling as you remove it
Internal Hard Disk Drive
removal
The following steps describe how to remove the Internal Hard Disk Drive. You will
need a screwdriver with a size #2
Phillips tip.
1. To remove the internal Hard Disk Drive, it is necessary to remove the CPU unit
first. To remove the CPU unit do the following substeps:
a. Unplug the GPIB interconnect cable at J110 on the A30 GPIB board and
and the LAN interconnect cable of the LAN interface board.
b. Unplug the interconnect cable from J100 on A50 AWG board.
c. Remove the two screws on the bottom and another two from the right side.
d. Lift the CPU unit up and out from the main chassis.
WARNING. Before doing this or any other procedure in this manual, read the
Safety Summary found at the beginning of this manual.
WARNING.
Before doing any procedure in this subsection, disconnect the power
cord from the line voltage source. Failure to do so can cause serious injury or
death.
CAUTION.
Static discahrge can damage any semicondauctor compornent and
hard disk drive in this instruments.