V O LTA G E A N D W A VEFO RM C O N D ITIO N S
Voltage Conditions
Voltages shown on this schematic diagram were measured w ith a Tektronix DM 502A Digital Multimeter.
Voltage measurements can vary as much as ±20%. No signals were applied to the vertical inputs or to EXT-
ernal trigger input.
Waveform Conditions
Waveforms below were taken from a Tektronix 475A Oscilloscope. Waveforms may vary as much as
±
20
% .
A 50 kHz, 100 mV sine wave was applied to the Channel 1 input and a 50 kHz, 2 V square wave was
applied to the Channel 2 input. A Tektronix SG 503 provided the sine wave and a Tektronix FG 502
provided the square wave.
442 controls were set as follows:
SOURCE
CH 1/CH 2
MODE
AUTO
SEC/DIV
10
u
s
VERT MODE
CH 1
Channel 1 VO LTS/DIV
50 mV
AC-GND-DC
DC
VAR (both)
Detent
M AG NIFIER
X I (out)
HOLDOFF
Fully CCW
Channel 2 V O LTS/D IV
1 V
Other controls were set as needed to obtain a stable display.
I V
1 0
ms
__i__ i__ ;— i__
j
i
,
i
1 V
1 0 0
ms
__ i__ i_____s__
!
•
i
i
Summary of Contents for 442
