Tektronix 442, Instruction Manual

Page: 132 / 170

V O LTA G E A N D W A VEFO R M C O N D ITIO N S
Voltage Conditions
Voltages shown on this schematic diagram were measured with a Tektronix DM 502A Digital Multimeter.
Voltage measurements can vary as much as ±20%. No signals were applied to the vertical inputs or the EXT-
ernal trigger input.
Waveform Conditions
Waveforms below were taken from a Tektronix 475A Oscilloscope. The oscilloscope input coupling was
set to dc. Waveforms may vary as much as ±20%.
A 50 kHz, 100 mV sine wave was applied to the Channel 1 input and a 50 kHz, 2 V square wave was ap­
plied to the Channel 2 input. A Tektronix SG 503 provided the sine wave and a Tektronix FG 502 provided
the square wave.
442 controls were set as follows:
SOURCE CH 1/CH 2
MODE AUTO
SEC/DIV
10
ms
VERT MODE
CH 1
Channel 1 VO LTS/D IV
50 mV
AC-GND-DC (both)
DC
VAR (both)
Detent
M AGNIFIER
X I (out)
HOLDOFF
Fully CCW
Channel 2 VO LTS/DIV 1 V
Other controls were set as needed to obtain a stable display.