Tektronix 071-0833-02, Instructions Manual

Page: 26 / 69

18
K4000 Transport Cart Instructions
Skyhook
Install the Skyhook. You will use these parts:
H
1 Sleeve
H
1 Adjustment Knob
H
1 Mount
H
2 Weld Nuts
H
2 1/4 20 Cap Head Screws, 1/2 inch length
H
2 1/4 inch Tooth Lockwashers
H
2 Bushings
H
2 Grommets
You will use the 3/16 inch Allen wrench included with your cart.
1. Press the two grommets into the large holes on either side of the keyboard
shelf.
2. Install the weld nuts, lockwashers and cap head screws on the mount as
illustrated. Leave each screw assembly loose; do not screw the weld nut onto
the cap head screw more than one full turn.
3. Prepare the skyhook by first pressing the bushings into the holes in the top
and bottom of the mount as shown in Figure 14. Next place the sleeve on the
inside of the mount and align the sleeve with the openings in the top and
bottom of the mount. Slide the skyhook through the top of the mount and
through the sleeve. Now install the adjustment knob and tighten lightly to
secure the skyhook.
4. Slide the skyhook assembly slowly onto the cart, capturing the weld nuts in
the track. Position where desired and then tighten with the 3/16 inch Allen
Wrench.
NOTE
. The skyhook can be positioned on either side of the cart.