Tektronix 070-9778-03, Service Manual, Page: 65 / 119

Maintenance
TLA 711 Color Benchtop Controller Service Manual
6–13
To remove the front panel hardware refer to Figure 6–4 and Figure 6–5 and
follow these steps:
Remove
screws (2)
Remove
standoffs (4)
Remove
screws
(2)
Figure 6–4: Removal and installation of the front panel hardware
1. Remove the four standoffs from the SVGA OUT, and COM connectors.
2. Remove the two screws from the LPT connector.
3. Remove the two flat head screws, located to the right of the PC Card slot.
4. DO NOT remove the nuts on the SMB connectors at this time.
5. Disconnect the 8-pin power cable located at the rear of the module.
6. Remove the six screws that secure the subassembly to the chassis.
Removal