Kona Micro Outdoor User Guide
T0005158_UG
Version 0.34
TEKTELIC Communications Inc.
Confidential
Page 16 of 32
3
Commissioning and Monitoring
3.1
Required Equipment
The following equipment is required for commissioning and monitoring the Kona Micro
Outdoor Gateway.
1.
A laptop running Windows XP/Vista/7.
2.
A Cat5 or better Ethernet cable.
3.2
Procedure
Once the DC power and GPS and LoRa RF antenna connections are in place the Kona Micro
Outdoor Gateway may be commissioned.
1.
Connect an Ethernet cable between the Host PC and the bulkhead copper Ethernet
connector (RJ45). For a PoE powered installation, a PoE power injector may be required.
2.
Apply DC power to the Kona Micro Outdoor Gateway. The initial current draw is
expected to be greater than 0.1A. If there is no current, the polarity of the DC power
cable connection may be reversed or the power source may not be configured properly.
3.
The Kona Micro Outdoor Gateway supports DHCP; from the Gateway MAC ID label on
the enclosure, determine the IP address using your local DHCP tools.
4.
Install the Tektelic Kona Factory Test Tool on a PC and follow the operating instructions
as detailed in the reference document T0004142_GUI_Instructions.