Kona Micro Outdoor User Guide
T0005158_UG
Version 0.34
TEKTELIC Communications Inc.
Confidential
Page 10 of 32
•
For the direct DC power input, the DC positive pin must be at positive potential relative to
the DC negative pin. If the polarity is reversed, the unit will not sustain damage but will not
operate until the connection polarity is corrected.
•
Although the Kona Micro Outdoor Gateway can be powered through either the direct DC
input or the power over Ethernet (PoE) input, simultaneous application of power to both
inputs may result in unexpected operation and shall be avoided.
•
The Kona Micro Outdoor Gateway power source must meet SELV requirements.
•
Always ensure the 3G/4G Modem SIM card access port is properly sealed after installing a
SIM card.
2.2
Unpacking and Inspection
The following should be considered during the unpacking of a new Kona Micro Outdoor
Gateway.
1.
Inspect the shipping carton and report any significant damage to TEKTELIC.
2.
Unpacking should be conducted in a clean and dry location when possible.
3.
Do not discard the shipping box or foam inserts as they will be required if a unit is
returned for repair or re-configuration.
2.3
Required Equipment for Installation
The following tools are required to install the Kona Micro Outdoor Gateway module:
1.
A 6 point metric socket set and torque wrench drive.
2.
Anti-oxidant compound (NO-OX-ID, Penetrox, Noalox, Ox-Gard or equivalent).
3.
A small wire brush.
4.
A clean cloth.
5.
Weatherproofing tape kit for the RF connector (Scotch Wireless Weatherproofing Kit,
WK-101 recommended).
6.
Appropriately sized pipe clamps for pole mounting or appropriate screws or bolts (four
sized M8) with any required anchors according to the wall construction for wall
mounting.
2.4
Kona Micro Outdoor Gateway Mounting
Kona Micro Outdoor Gateway is designed to be mounted to a vertical pole or wall using the
supplied mounting bracket which attaches at the four screw locations on the back of the
module illustrated in Figure 3.