11
Chapter 6. Quick Start
Tips
：
Assure that USIM doesn
’
t activate the caller transferring function and in
coming call display,close the PIN code as well.
1.Power on/ off
Power on: turn the power switch to upside
“
On
”
position. The indicator light
will be on continuously with red color for 3-5 seconds, then change to flash
slowly. After about 35 seconds, the indicator light changes to green color and
flashes slowly (indicates disarming status) or green color lighted continuously
(indicates arming status), which indicates that the camera has found the network
and begun to work. At this moment, a sound of
“
tick
”
can be heard from the
camera. More information of the status please refers to indicator light status
instruction.
Power off: Turn the power switch to downside
“
Off
”
position.
2. Start Remote camera
Dial a voice call to the camera by your mobile,it automatic default your mobile
number as authorized Number after getting through.
After successful start, your mobile phone will get a reply SMS:
“
welcome to use
3G remote camera,the password is 1234!
”
At this moment, your mobile phone has been set as authorized Master number..
Note
:Make sure that no authorized number set before performing above
operation,if the camera has set before,please delete the old authorized mnumber
or reset (hardware reset/SMS reset)the camera,then set new authorized number.
3. Active remote control
After starting, press and hold the
“
Set
”
key at the rear board of the camera for 2
seconds. The indicator light changes to flash with orange color indicating that
the camera has switched to loading status. Then press any key of the remote
control to send signal to the camera, the indicator light of the remote control will
turn on. After receiving the new remote control signal successful, a
“
tick
…”
can
be heard from the camera. Press
“
Set
”
key again to exit the loading status.
Otherwise, it will automatically exit after 30 seconds.
