Teknic EF-785, Installation Manual, Page: 64 / 90

19. Ambient Operating conditions must be in the range of 0°-40°
Celsius.
20. The machine must not be hand held.
21. The machinery must not be for use in explosive environments.
22. The machine must meet or exceeds all current international
standards for human factors engineering and ergonomics.
23. The machine must not be a vehicle, and once installed must not
be mobile.
24. The machine must not used for underground work.
25. The machine must not move or lift people.
26. The machine must be designed with a low center of gravity and
the mounting of the machine must prevent any hazardous
motion, movement, or turnover.
27. Software must not have the ability to override the
electromechanical safety logic within the eF-785.
WARNING:
To the best of our knowledge, at the time of the writing of this manual the
guidelines described herein meet the following EN standards:
•
•
•
•
•
EN 954-1
EN 60204-1
EN 61010-1
SEMI S8
SEMI S2
These guidelines are no substitute for a proper evaluation of risks and
a careful review of the appropriateness of the safety system. In fact,
meeting the EN standards and the Machinery Directive may be
insufficient to protect personnel and property.
The user of the eF-785 must perform a careful, exhaustive Failure
Mode Effects Analysis (FMEA) for their machine safety system and
decide if the level of protection is appropriate. Teknic can furnish you
with an FMEA for the eF-785 that has been provided to us by a third
party testing laboratory which you can use to help you prepare this;
however, the responsibility for the entire safety control system’s design in
your machine is your responsibility. Teknic does not warrant that
installation of the eF-785 in your machine according to these instructions
will prevent accidents, injuries or deaths.
62
V
E R S I O N
1 . 4 2 / A
U G U S T
2 6 , 2 0 0 5