Preliminary Manual
Page
8
HEADSTOCK SWIVEL OPERATION
For
turning bowls
than the inboard capacity of
the
headstock can
be rotated throught
1.
Unscrew the headstock retaining
nut
(located between the bed rails under
the
headstock) sufficiently to rotate the securing plate parallel to the gap between the
bed rails.
2.
Make sure the bed rails under headstock are absolutely clean with no woodchips
or
even wood dust to
foul
the reseating
of
the headstock.
90-94
12-004
3.
Lift
unit clear of bed rails,
turn through
90
deg. and
on the bed
room
on
the left of the
or Outrigger unit.
4.
Rotate headstock securing plate to again
cross both beds at 90 deg.
Check underneath to see that the securing
illustration right.
5.
Do
nut
up finger tight.
6. Try
to move headstock back and
forth
to make sure it is seated properly.
7.
Tighten
nut
up one quarter turn with spanner.
to position the
late
is
square across the beds.
Securing plate must be square to beds
N D E X
The
is equipped with a
24
division spindle index.
The index unit is located above the spindle housin
.
Sight hole for the index numbers is located to the eft of the spindle index.
To
spindle index simply twist wheel until the larger central index pin drops
into the
positions in headstock pulley.
To disengage pull wheel forward and twist to one side.
Make sure the guide pin drops into the indentation provided.
This will prevent index pin accidently re-engaging while spindle
is
turning under
power.
If
you have difficulty reading the number through the sight hole with larger diameter
work mounted, use
a small hand mirror.
P
R e q u i r e d :
I n d e x
2
3
0 8 6
6
1 2
Summary of Contents for NOVA TL1200
Page 1: ......
