Teka GCO3G1P, User Manual

Page: 13 / 91

4.1 USE OF COOKERS CONTAINING GAS
Surely and carefully read the instructions that were enriched with pictures for your use of
convenience and to be able to get the most efficiency from your apparatus.
The signs on the control switches, states that which cookers are turned on by them. Use
your electrical lighter or match to turn on any cooker containing gas. Press onto the
switch, turn to maximum at the opposite of clockwise. Each cooker can operate at
maximum, minimum, moderate and powers among them. These positions are shown with
maximum and minimum signs apart from off “0” position on switches. You can adjust to
wished location by turning the switch from off position opposite to clockwise and carrying
it out in a suitable manner to the signs. Also, to turn off the apparatus,it is required to turn
the switch clockwise and until it stops (It stops at “0” location).
IMMEDIATE Ignition System in Cookers
Some models have immediate ignition system on cookers. You can easily recognize them
via the turning on spark plugs. To operate the system; it is required to press slightly onto
the switch marked with its symbol, as turning the switch of the cooker that you want to turn
on opposite to clockwise.
In order to obtain the most efficiency from the cookers, pay attention to the sizes of
saucepans that you put the on the cookers and the sausepans to have flat bases. Do
not use concave and convex based saucepans. Pay attention to use saucepans that have
sizes determined in figure. If the dishes that have less than 14cm diameter,
use a coffee pot carrier.
Gas Flame Failure Device (FFD) (If Your Product Has This Feature)
Gas flame failure device is used for every flammable gas in order to prevent the gas
leakage by the result of turning on the gas taps by the children randomly or
dieing down that may occur by the result of overflowing of liquid on upper flammable ones.
Turn the switch opposite to clockwise onwards. This situation will ignite automatically one
after another. After the turning on, when the switch is hold on pressed location for
approximately 3 seconds as pressing forward until the point where the switch reaches, the
thermic component senses the cooker’s flame and opes the gas way. At dieing out that
may be because of overflowing of liquid and such reasons, the thermic unit senses the loss
of heat and cuts off the gas way in a time period less than 60 seconds.
Part 4 : USE OF YOUR OVEN
4.2 USE OF OVEN PART - GAS COOKERS
4.2.1 Oven Burner
Ignition of the oven burner can be performed in two ways, depending on the model of your
cooker:
Ignition by Spark Button : If your oven is equipped with a spark button, you should press
the oven valve and rotate the valve knob to the point where you want to perform the
cooking, while also pressing the ignition button. As the valve is equipped with a Flame
Failure Device (FFD), please follow the procedures explained under the clause 4.3.
Take spark button will automatically create sparks between the spark ignitor and the burner,
causing the ignition to occur. As soon as the ignition occurs, the spark button can be
released.
4.2.2 Grill Burner and Roasting Skewer
The operation of the Grill burner is not dividedinto temperature grades, it only operates in
a single mode to create a constant source of heat. To do this, the valve of the grill burner
should be rotated until the designated marker for grill.
Ignition of the grill burner can be performed in 2 ways, similliar to the oven burner.